Question Próbowałem przypomnieć sobie gotowanie w garnku. Myślę, że mam rację, czy ktoś może pomóc?

chewie12321

Don't buy from me
Member
Language
🇺🇸
Joined
Feb 25, 2024
Messages
3
Reaction score
2
Points
3
Ok, minęło trochę czasu, odkąd przejrzałem całą tę wiedzę, ale jestem tutaj i upewniam się, że mam szczegółowy raport z czasów, kiedy zajmowałem się produkcją niektórych rzeczy, a tym, którego nauczyłem się dobrze, była meta, nauczyłem się anhidris amoniaku dope red ad black i innych cold cook, które zamierzałem po prostu wypróbować dla prostej twarzy pewności, że nie muszę iść do dealera i niczego kupować, po prostu dbać o moje nawyki i to wszystko, ale utknąłem w szczegółach.

1 uncja NitroMethane GaI
2 Chmiel numer 9 do niebieskiego pistoletu 7 uncji
3 Pręty spawalnicze pomarańczowe końcówki dla nichole
4? Wierzę, że jest tam aktywowany charchol, ale nie jestem pewien.
5 Taśma pokrywka w dół szczelnie gotować na wysokim przez 12 godzin, a następnie pozostawić do ostygnięcia przez 12 godzin.

Po zakończeniu są dwie warstwy, jedna górna warstwa, która jest całą metą, którą należy odciąć od dołu, wyrzucić dolną warstwę i upewnić się, że nie dostanie się do kryształu, ayer może być trujący.
 

whirlwind

Don't buy from me
Resident
Language
🇺🇸
Joined
Dec 15, 2024
Messages
13
Reaction score
4
Points
3
I knew about this when I was younger. It's a way to make meth that is more friendly to apartments or hotels and something about the pressure exerting on the reaction produced this like golden, syrupy yellow reaction mixture, much deeper in color than any not from a pressure cooker.
YOu go to La cer d' table or something like that, it's a high end kitchen store and they had these huge, tall pressure cookers that had 6-9 twist down clamps around the lid to keep it on. The procedure is less exciting though.
1. Get a 1 gallon fuel can from the gas station and pivot it so its on its side where you can see the bottom corner directly through the lid spout. Pour your I2 down there so that it settles on that specific side of the bottom of the can. Next, slowly do something of the opposite, pivoting it so that while the I2 stays on the other side you've also lifted the other side where you carefully pour all your hypo. With this, if your careful and brave you've managed to put both reactants in the gas can without allowing them to mix yet. Quickly screw down the gas lid, once its on shake that bitch a good few times and toss her like 20 feet away. It'll fume a little, puff up like a marshmellow and appear like it's gonna pop at any moment but after an hour you can easily remove the lid, theres no pressure, and pour out the HI acid into a mason jar.
2. Put the holder thing into the pressure cooker that allows you to put mason jars around it in a circle without letting them falll over. Divide your pse amongst your jars and your HI into those as welll. It doesn't react when put on the pse so its chill now.
3. Screw the mason jar lids on tight and put a good amount of water in the cooker. Screw down the lid and put it on the stove for like 20-26 hours.
It's allow the reactions in each jar and when they come out the rx looks crazy thick but following that its all the same.
Just a way to make it more family friendly or urban friendly I guess. I always liked the product better than others but its a little time consuming and industrial pressure cookers, while looking less suspicious than glassware, do stand out.
 
Top